Drinking Water

Yes, Brandon adds fluoride to your drinking water. Fluoride has been added to public drinking water supplies to fight tooth decay.

Hardness is a measure of the amount of minerals, i.e. calcium and magnesium, dissolved in water. The average hardness of water is 150mg per liter.

The taste of water is caused by the minerals and naturally occurring organic substances dissolved in the water. Some of these substances impart a strong taste, while others do not. Taste in water is a complex issue involving many factors: individual preferences, taste sensitivity, seasonal changes, water source(s), salt levels, water temperature, medications, home plumbing, and many other factors. Your water is continuously tested and monitored to ensure that it is safe for consumption.

A single colorimetric test should not be used to provide the basis for safety claims. Assertions regarding water safety should be ignored when an individual wants to sell you something based on a single, quick and cheap colorimetric water test.

Yes. Many studies have shown that the amount of chlorine found in treated water is safe to drink. Chlorine is needed to maintain disinfection throughout the water distribution system. The potential for risk from microbial contamination outweighs any risk associated with chlorine.

Cryptosporidium is a parasite that travels in an oocyst (hard shell) and thrives in the intestines of mammals, including humans. Cryptosporidium is widespread in the environment. Oocysts have been found in rivers and streams, lakes and resevoirs, raw and treated sewage, and treated surface waters. The organism has also been found in both wild and domesticated animals.

The Cryptosporidium organism can cause severe intestinal illnesses in humans called cryptosporidiosis. Once oocysts are ingested, a person may become ill in two to 12 days. Disease symptoms include: diarrhea, abdominal cramps, nausea, occasional vomiting and low-grade fever. Cryptosporidiosis typically lasts 10 - 14 days, may linger off and on up to 30 days, and can persist for extended periods.

Children, the elderly, and "high risk" individuals, e.g. the terminally ill, and AIDS/HIV individuals, may be the most susceptible. It is especially important for these persons to see their physician as soon as possible so they can be properly diagnosed.

Not everyone exposed to the parasite Cryptosporidium shows signs of illness. Infection can occur from eating contaminated food, exposure to fecally contaminated environmental surfaces, e.g counters, change tables, swimming in contaminated water, and from person-to-person contact through the fecal-oral route.

Cryptosporidium can also be transmitted from one animal to another through cross-transmission. For example, organisms from cats, cattle and pigs are able to cause infection in humans, and organisms from humans can infect animals.

To guard against an outbreak of Giardia lamblia and Cryptosporidium, our water treatment facility practices a multi-barrier approach utilizing coagulation/filtration along with chlorination and ultra-violet disinfection of the water before it leaves the facility. The parameters are monitored with collected samples submitted for analysis.

All drinking water sources have potential to contain micro-organisms, such as bacteria, viruses and protozoa, that may cause serious illnesses. Drinking water is disinfected to destroy or inactivate those micro-organisms.

Chlorine is the most common disinfectant added to drinking water in the world. It is an effective disinfectant. However, when it is added to water with organic matter (ex: decaying plants and algae) by-products can form. Trihalomethanes (THMs) are the most common type of by-product.

Chlorine has been added to drinking water to get rid of harmful micro-organisms since the early 1900s. If harmful bacteria, viruses or protozoa are distributed through a drinking water supply, a lot of people can get sick very quickly. Using chlorine has greatly reduced the number of waterborne disease outbreaks (illnesses caused by micro-organisms in water) for over a century.

While there are other disinfectants, chlorine is used the most to disinfect water because it works, it’s low cost and it’s easy to use. It also helps in keeping the pipes that carry water to communities free of harmful micro-organisms that can get into the water after it leaves the treatment plant. Other disinfectants (ex: ozone or ultraviolet (UV) light) can’t help protect water after it leaves the treatment plant.

Water with high organic content will generally form more THMs than water with low organic content. Water sources with higher organic content include:

• surface water (ex: lakes, reservoirs, rivers, streams)
• shallow or poorly-built wells or springs that may be at risk of contamination from surface water

Filtering water before adding chlorine helps reduce the organic content and the THMs.

Groundwater from deeper wells usually has lower organic content and less THMs.

The current Canadian guideline is 100 micrograms per litre (μg/L) or 0.1 milligrams per litre (0.1 mg/L). The guideline is an annual average based on four tests taken over a year, usually at the point in the distribution system where THMs are most likely to occur. This guideline is the same as the standard for water systems in Manitoba, set by the regulations under The Drinking Water Safety Act.

As a precautionary measure, drinking water guidelines are set to ensure a very low level of potential health risk over a typical lifetime of exposure (70 years). The guideline value is set to protect against the potential for fatty changes to liver cells at high levels of THMs. This effect has been observed in animals but the impact on humans is unknown. While there is not enough evidence to indicate that THMs cause cancer in people, cancers have been detected in some studies in which animals (mice and rats) were exposed to high doses. Further study is needed. Short-term use of drinking water that exceeds the guidelines is unlikely to have an impact on human health.

Drinking tap water containing THMs, showering, bathing and using water for recreation (ex: swimming, hot tubs) can all increase THM exposure. THMs can be absorbed through skin or inhaled by breathing water vapour when showering, bathing, etc. Exposure from a 10-minute shower or 30-minute bath is about the same as drinking two and a half litres of cold water. All of these types of exposures and normal daily activities were considered when setting the Canadian guideline and the Manitoba standard for THMs in drinking water.

Water systems that rely on surface water sources, or groundwater sources that can be affected by surface water, test for THMs regularly. Most surface water systems have to measure THMs four times a year, every two years. Larger surface water systems measure THMs four times a year, every year. Samples must be taken four times a year because water quality changes over the year - THMs are usually higher in the summer and lower in the winter. The average THM value for the year must be below the provincial standard.

The most common way of reducing THMs is to remove organics from the water source before adding chlorine. This is done by:

• allowing the organics to settle out
• filtering the organics out
• using some other type of advanced water treatment

Once the organics are removed, chlorine can be added to disinfect the water without forming high THM levels. If water suppliers have difficulty meeting the THM standard, it is usually because they do not have a water treatment process to remove organics before adding chlorine or their water treatment process is not removing enough organics.

For details on the THM levels in your water system, contact your water supplier or the drinking water officer in your region. Large, public water suppliers must make annual reports available to the public, and post a copy of that report on the Internet.

You can lower your THM exposure by using a home water treatment system, such as a filter. This can be a point-of-use (POU) filter at the kitchen tap or a point-of-entry (POE) filter, where the water enters the house. Treatment systems range from water pitchers with a carbon filters to whole-house treatment units. Taking shorter showers and baths can also reduce THM exposure.

If you buy a home treatment system, look for filters or equipment that have been certified by an accredited organization to remove THMs. Certification standards help ensure the safety and performance of retail products for drinking water.

The THM removal standards are set by NSF International or the American National Standards Institute (ANSI). Certification organizations make sure the treatment filters and equipment meet these standards. Accredited certification organizations include:

• NSF International
• Canadian Standards Association (CSA)
• Underwriters Laboratories Incorporated (UL)
• Water Quality Association (WQA)
• Quality Auditing Institute
• International Association of Plumbing and Mechanical Officials (IAPMO)

Always follow the manufacturer’s instructions on how to use and maintain any home water treatment filters or equipment.

For health related questions on THMs, call Health Links at 204-788-8200 or toll free at 1-888-315-9257 or your local public health office.

For information on home water treatment, call NSF International’s toll free hotline at 1-877-867-3435; or go to: www.nsf.org. Health Canada also has information on home water treatment equipment on their website at www.hc-sc.gc.ca.

For details on Health Canada’s THMs guideline, visit www.hc-sc.gc.ca/ewh-semt/pubs/water-eau/trihalomethanes/index-eng.php.

For more information on chlorine in drinking water, go to www.hc-sc.gc.ca/hl-vs/iyh-vsv/environ/chlor-eng.php.

For more information about drinking water in Manitoba, contact Manitoba Water Stewardship’s Office of Drinking Water at 204-945-5762, or refer to the website at www.manitoba.ca/drinkingwater to find a local office near you.